Difference between revisions of "Processing Video from Depth Sensor"

From iPi Docs
Jump to: navigation, search
m
Line 1: Line 1:
* Run [[iPi Mocap Studio]]
 
* Press <tt>Ctrl+N</tt> or push '''New''' button on toolbar to create new project (1)
 
* Choose recorded [[.iPiVideo file extension|'''*.iPiVideo''']] file
 
* After video opened, background will be calculated automatically and position of camera will be detected based on floor plane.
 
* Make sure, that floor is detected correctly:
 
*# Right mouse button down on 3d view port area
 
*# Move mouse, as a result 3d scene will be rotated
 
*# Right mouse button up
 
*# Visually control that 3d points from floor are located on ground plane which is marked by squared grid
 
 
[[Image:KSensor-process-step2.png|thumb|center|400px]]
 
 
{{Note|You always can get back to the camera point of view by pressing <tt>'''1'''</tt> key  on keyboard or pushing “Camera 1” button on toolbar}}
 
 
 
* Save created project by pressing <tt>Ctrl+S</tt> or pushing button '''Save''' on toolbar (2)
 
* Save created project by pressing <tt>Ctrl+S</tt> or pushing button '''Save''' on toolbar (2)
 
* Position timeline slider to the frame where actor is in T-pose (3)
 
* Position timeline slider to the frame where actor is in T-pose (3)

Revision as of 08:32, 3 November 2014

  • Save created project by pressing Ctrl+S or pushing button Save on toolbar (2)
  • Position timeline slider to the frame where actor is in T-pose (3)
  • Adjust actor height using appropriate slider on tab Actor (4)
  • Select Move tool on toolbar. (5)
  • Move actor model to left or right to match roughly actor silhouette on video.
Note.png
Note: Actor model can look smaller due to its position along axis of view. Don’t pay attention to it on this step.
KSensor-process-step3.png
KSensor-process-step4.png
  • Switch to Tracking tab and push Refit pose button. (6)
  • As a result model should be matched with actor image from video. If it does not happen then delete result using item Edit > Delete pose from main menu and repeat above actions.
  • Using the slider right to the button Show Skin in toolbar, make sure that morph of model corresponds to the actor image (7).
    • If no, than adjust chest/bust/waist/hips/belly morph using appropriate sliders from Actor tab (8).
  • Set the beginning of Region-of-Interest (ROI) to the current frame with T-pose by pressing I key on keyboard or by double-clicking on the left edge of ROI bar under timeline (7).
  • Switch to Tracking tab, change tracking options (Head tracking, Shoulders and Spine) if required (9).
  • To start tracking just push Track Forward button (10).
  • Wait and watch...