Difference between revisions of "Processing Video from Depth Sensor"

Revision as of 08:37, 20 April 2017

• Save created project by pressing Ctrl+S or pushing button Save on toolbar (2)
• Position timeline slider to the frame where actor is in T-pose (3)
• Adjust actor height using appropriate slider on tab Actor (4)
• Select Move tool on toolbar. (5)
• Move actor model to left or right to match roughly actor silhouette on video.

Note: Actor model can look smaller due to its position along axis of view. Don’t pay attention to it on this step.

• Switch to Tracking tab and push Refit pose button. (6)
• As a result model should be matched with actor image from video. If it does not happen then delete result using item Edit > Delete pose from main menu and repeat above actions.
• Using the slider right to the button Show Skin in toolbar, make sure that morph of model corresponds to the actor image (7).
  • If no, than adjust chest/bust/waist/hips/belly morph using appropriate sliders from Actor tab (8).
• Set the beginning of Region-of-Interest (ROI) to the current frame with T-pose by pressing I key on keyboard or by double-clicking on the left edge of ROI bar under timeline (7).
• Switch to Tracking tab, change tracking options (Head tracking, Shoulders and Spine) if required (9).

Tip: Check Use fast tracking algorithm (BETA) option to use fast algorithm. This option only affects Track Forward / Track Backward. This algorithm may be less accurate in some cases, but its tracking speed is up to 2.5 times higher, depending on particular hardware and tracking options.

• To start tracking just push Track Forward button (10).
• Wait and watch...

Note: Use old tracking algorithm option (11) allow to use old algorithm. You can use this in case default tracking crash (rare case).